[!Refreshapp] when skin loaded?

Hi again
I need a little help!
So, I finally got myself a microphone and now will be using the Mic skin I made a few years ago.

Trouble is, I have two skins:
A Volume/VUmetre skin
The Mic skin.

I've got it working, though probably not the best way, where when you plug in the mic, it's a USB lead, the Volume skin detects the Mic Volume and loads the Mic config. Unplug, and the config is deactivated. So far so good. Is there a better way to detect the mic is connected/disconnected?

However, The Volume skin needs updating as it doesn't react to the volume input of the mic until that skin is refreshed.

So I set up this code in the volume app to load and unload, but refreshing the app causes a 'Refresh' loop:So I then checked the manual to see if there was an option to do something similar to OnRefreshAction=[RefreshApp] in the Mic skin. Obviously using that would create another loop. So I wondered if there's a way to have something like OnStart=[RefreshApp] or OnLoad=[RefreshApp].

Any ideas? Thanks.

Statistics: Posted by sl23 — June 12th, 2024, 10:59 pm — Replies 5 — Views 177

---